Sunday 1 February 2015

Working it Out








All week I mass produced bias strips, pressed and fancy-stitched until I finally had enough oversized wonky squares to trim down into blocks and setting triangles. I did not actually know what size I was aiming for until I could figure out the largest square I could make from the ones that were destined to be setting triangles. I had started off with 20” square pieces of fabric that were eventually trimmed to a mere 12.5” then I worked out the other sizes accordingly in a backwards, roundabout way. By the time the quilt top is all connected I might even have to add an outer border to make sure its overall size fits certain competition categories. This maths may have been a bit challenging but not nearly so grim as Freya’s Higher Maths Prelim exam;)

There are lots of large offcuts from this quilt that might come in handy for some sort of project later on. I could use them for notebook covers or employ them more purposefully as crazy scraps in another freeform quilt.

The pieced blocks are bulky - they all have a layer of fusible interfacing, loads of stitching and thick bias strips. I will use a skinny needle and a straight stitch plate to sew them all together. The quilting looks like it could be fiddly - I don’t have a firm plan yet, just some scribbly sketches which are likely to morph. I have a pile of paperwork to attend to before I start on the next phase.

I have resigned my role as the UK’s rep for APQS after 5 years. I would like to be clear that I have parted on good terms with APQS and handed over to Ani and Kay. I do have other irons in the fire, as well as that Unfinished Book and all will be revealed before too long…


Excitingly, the trip that Ellen, Kay and I will make to Paducah in April is shaping up nicely. Almost all of the arrangements for flights, hotels and car-hire are sorted. We just need to book a couple of classes and decide which quilt shops to visit. I think we are all looking forward to a trip in the Spring that is just for fun:)

No comments:

Post a Comment